Staun Tire Deflators Automatic 15 - 55 psi destination pressure range, tire deflators (green package)

4 × 6 × 0.88 in
0.36 lb
Tire & Wheel Accessories
Automatic Tire Deflators
Coyote Enterprises

Staun Tire Deflators are warrantied for five years*. They are a spring loaded check valve with the ability to vary the spring pressure on the check valve via the Adjustment Cap. More spring pressure means a higher destination**, shut OFF pressure. Less spring pressure means a lower destination pressure. The Staun Tire Deflators destination pressures are: SCVLD, 1 to 10 PSI; SCV5, 6 to 30 PSI and the SCVHD, 15 to 55 PSI.
The Adjustment Cap is held in place by the Lock Collar. Never use pinching tool like pliers or vice grips for they may distort the Main body and cause the deflator to malfunction. This voids the warranty. Only use your fingers.
As tires warm up, the pressure increases. To pick up that increase from a cold morning air down, just screw the deflator back on the tire valve stem and pull the piston using the notch in the end. Wait for it to shut OFF. Expect only a few seconds of air flow since this is typically only a small pressure increase.
* Abused, misused and lost parts not covered.
** DESTINATION PRESSURE: The pressure you have set where the deflators will automatically turn OFF.
Low tire pressure makes for unfamiliar vehicle handling. Never deflate your tires unless you have a way to reinflate them to the pressure recommended by your vehicle or tire manufacturer. Compressed air (gas) presents several hazards, so always use protective eyewear when setting or using your Staun Tire Deflators. Never completely remove the Adjustment Cap from the Main Body while screwed on an inflated tire. This will shoot parts out of the deflator body and may result in serious injury.